AK MASTER MOUNT™ ENHANCED SAFETY LEVER

AK MASTER MOUNT™ ENHANCED SAFETY LEVER

We have taken the traditional AK safety lever and “tactically” enhanced it for the modern AK user. The AK Master Mount™ version of the AK safety lever is rugged 16 gauge steel (1.5 mm thick), has an improved ergonomic extended side tab, bolt-hold open feature, and is fully compatible with the AK Master Mount™ side rail mounting hardware.

Note: Not compatible with underfolder stocks.

AKM Version

Our AKM version enhanced safety lever is for the stamped receiver.

It can be modified to fit thicker milled receivers by enlarging its "gap."

See our website's "support" tab for further information.

No Other Safety Lever Compares

Our AK Master Mount™ safety lever safety levers are stamped from heavy duty 16 gauge (.060" or 1.5 mm) thick steel, thicker than all the other AK safety levers on the commercial market or those made by the factory!  The extended side tab is also thick 16 gauge steel.  This makes it rugged and robust, and it will not cut your finger like the safety levers with "razor thin" side tabs.  The side tab is textured on BOTH sides for better traction, especially if wearing gloves.  The tab is also flat to be easy to move the safety lever in the up AND down directions, and it is angled slightly upward from back to front to be more ergonomic.  Then finally it is heat treated to Rockwell C hardness of 30 for added toughness.  

Solid Steel

The internal paddle part of the AK Master Mount™ enhanced safety lever is milled from solid steel.  It is NOT cast like most of the AK safety levers these days. It is heat treated to Rockwell C hardness of 30 for even more toughness.

Yes, we overbuild our products as we are AK purist.  We make a semi-automatic and full-auto configuration.

 Correct Safety Lever Stop

The lower edge has the correct embossing to prevent the safety lever from over-riding the safety lever stop tab that extends up from the trigger well. 

 Robust Construction

The distal end of the AK Master Mount™ enhanced safety levers have a stiffening ridge incorporated into the stamping to provide greater strength and rigidity under the bolt-hold-open notch.  There is also a distal smaller side tab for an additional finger purchase point, plus it adds even further strength to the end of the lever. 

Bolt Hold Open Notch (BHO) Version

Since many shooting ranges require the bolt to be open when the firearm is not in use, our enhanced safety levers come with a bolt hold open notch. The front edge of the notch is "hook shaped" to firmly wrap around the charging handle.  This Bolt Hold Open notch is a version available in both our AKM and Yugo version safety levers.

No Bolt Hold Open Notch (BHO) Version

Since many AK users prefer a more traditional looking safety lever, we also offer our AKM and Yugo version enhanced safety levers (both semi-auto or full-auto configurations) in a no BHO notch version.